Single Bay Charger The Single Bay Charger features a charging bay that can accomodate both a CR3 unit or a CR2 unit with or without a boot. A power supply and wall mount are included with your charger. Plug the power cord into the back of the unit and plug the adapter into a wall socket. The unit features an LED for displaying the charge status. The LED will remain red until the unit is fully charged. Once charged, the LED will turn green. The approximate charge time is 4 hours. Note: You must upgrade the firmware in your CR2 and CR3 unit to 3484 or higher for the charging status LED to work properly. Installing the Single Bay Charger to the Wall Mount. The charger comes with two (2) screws that mount the single bay charger to the wall mount. After installing the wall mount to a wall (screws not included) follow the step below to install the charger: Correctly Inserting a CR2 or CR3 Unit Single Bay Charger To charge a CR2 or CR3 unit, place the reader into the bay with the buttons facing you, aligning the connector to the post. C003838_01_Single Bay Charger_Quickstart Guide ? 1 C003838_01_Single Bay Charger_Quickstart Guide ? 2 C003838_01_Single Bay Charger_Quickstart Guide ? 3
|