Specification - Mfr Part Number: FSP270-50SNV
- Features:
- Passive PFC(Power Factor Correction) circuit at 230 V AC
- High efficiency
- Low ripple & Noise
- Output over voltage protection
- Short circuit protection on all output
- Safety approved: CSA, UL, IEC, TUV, NEMKO, CE
- 100% burn-in under high ambient temperature (50XC)
- Vacuum-impregnated transformer
- MTBF: 100K hours at 25?C
- 100% Hi-pot tested
- Line input fuse protection
- With 8cm fan
- Input:
- Voltage: 230 VAC
- Frequency: 47 ~ 63Hz
- Input current: 3 amps maximum / 230 Vrms, 50 Hz
- Inrush current: 80 amps cold, 90 amps warm measured at 264 Vrms
- Total Watts: 270 W
- Connectors: 1x 20pin main power; 1x 4pin P4; 3x peripheral; 1x floppy
- Remote ON/OFF Control: The Power supply shall accept a logic open collector level which will disable /enable all out put voltage (excluding +5V standby)
- Transient response: output voltage recovers in less than 1 ms max. following a 25%load change
- Hold-up time: 10.0ms minimum (at 230V / 50 Hz)
- Dielectric withstand: input / output 1800VAC for1 second, input to frame ground 1800VAC for 1 second
- Efficiency: 65% min. at full load
- Power good signal: turn-on delay 100~500 ms
- Over voltage protection: +5V, +3.3V, +12V
- Dimension (WxLxH): 125 x 130.3 x 63.5 mm
|