|
This
Shore A Digital hardness durometer is used to measure the
hardness of rubber and plastics according to ISO 868-1986
and ISO 7619 It has 8.1N total measure force, 1kg
outside pressure, pressure needle top cone angle of 35°,
2.5mm needle length, 0~100HA dial scale and
and features large LCD display for easy reading. It can
be use as portable or desktop.
Type A durometers is applicable to test the penetration
medium hardness of rubber, plastic, leather, multi-grease,
wax, etc.
It corresponds the rigorous standards
of ISO 868-1986 for Plastics and Rigid rubber and ISO 7619
Rubber in measuring indentation's hardness as well as GB/T
531.1-2008 standard. The measured hardness of a body makes
possible conclusions on its characteristics e.g. about how
quickly it breaks or is being scratched.
NOTE: ¹ A minimum
thickness of 6mm as sample test probes is recommended for
measurement's optimal results (if its less you
may add more layer but should be not
****** **
more than 3 layers) and measuring
point of at least 18mm distance from the
outside edges.
*******
² It is recommended that measurements
be made with the type D durometer when the value is above
90 HA
Special
Features
-
Dial
Scale is 1-100HA
-
High
grade probe with 0-2.5mm Pointer journey
-
Wide
measuring range with high resolution and ease of operation
-
35º
included angle with 0.5HA resolution
-
Hold
Function
-
With
Zero setting
-
Clear
test value
-
Stress
at the end of pointer: 8.1N
-
Easy
to read large LCD display
-
Delivers
ultra accurate reading
-
- Small
in the dimension, lightweigt and can easily be transported
-
Passed
and conforms with ISO 868-1986 & ISO 7619
international standards
-
Comply
with GB/T 531.1-2008 standard
-
With
CE Marking, conforms with European health &
safety requirement
Specifications
-
Resolution:
0.5HA
-
Total
measure force: 8.1N
-
Outside
pressure: 1kg
-
Pressure
needle top cone angle of 35°
-
Needle
length: 2.5mm
-
Flat
cone point: φ0.79mm diameter
-
Dial
Scale: 0~100HA
-
On/Off
Switch
Set
Includes
|
