2 x Supervisor 1A engines with PFC1 policy engine and MSFC1 routing engines, so it is Layer 3 capable. 128 MB RAM on both MSFC cards, and 64 MB RAM on both switching engines. 16 MB BootFlash on both switching engine and MSFC card. Not sure if this is upgradable. 3 x WS-X6248. These are regular 10/100 non-PoE ports. 2 x Power supplies. 1 x Power cord. Does not include console cable. Currently setup in Hybrid mode. (Running CATOS 5 on switch side and IOS 12.1 for MSFC1 on the router side). I think the bootflash is too small to accept larger than a 16 MB bootflash SIMM, and unsure as to if I can get it to boot both sides from the PCMCIA slot. Will be reset to factory defaults and no passwords on switch and router. Just ran out of money and patience with all the compatibilities for hardware and software for this complex switch. It is tested and works, just didn't have the money and patience to get it's full potential out of it. Prefer Cash Only, and no warranties. Tested power-on Good.