Click Here. Double your traffic. Get Vendio Gallery - Now FREE!

 

Battery Condition Indicator -Solar System, Forklift, Golf Cart or other 48 volt DC battery powered equipment.

For use on any equipment where the battery status is important.  It is specifically designed for battery power equipment to monitor the charge status of the battery or batteries.

Some mechanical aptitude is needed to make the installation. If you are not capable of finding an appropriate voltage supply, you may need to seek the help of a professional for installation.

The only available instructions are provided below.

• Battery Status
  • The battery meter has 10 LEDS that will light to show the battery condition. When fully charged, only the 10th LED will light shown a green LED.
  • As the battery discharges, successively lower LEDs will light; the 9th, 8th, 7th and so on lighting only 1 LED.
  • At approximately 30% battery life, the #3 LED will light and the color is Yellow as a caution indicator.
  • At approximately 20% battery life remaining, the #2 LED will light as a Flashing Yellow.
  • When the battery discharges to approximately ~10% remaining life, the #1 LED will start FLASHING RED with the #2 LED FLASHING Yellow alternately.

It is recommended to have the battery or batteries recharged when the #3 LED lights Yellow as a safety margin to prevent dead batteries.

CAUTION: CAUTION: This is not a full proof device and no warranty is made that your battery/batteries is/are in good condition.  

Reading 10 LEDs, #10 being fully charged and #1 being fully discharged Voltage Indicator Range for Solar Systems, Golf Carts, Fork Lift Trucks and other battery powered equipment. 49.31 volts full; 41.52 volts empty   Weight 2 Ounces Voltage Supply 12 or 24 Volts DC Temperature Range -40 to 185 Fahrenheit; -40C to 85C Power Consumption 0.2 to 0.3 Watts Dimensions Width 2.125" Depth Behind front meter flange to end of mounting screws  - 1 15/16 inches Hole size - 1 3/8 " wide by 15/16"  Installation Connections The terminal marked "+" is for positive volts. The terminal marked "-" is for ground. These must be hooked up for the indicator to record battery usage. With only these two terminals hooked up, there will be no display showing. This is done to conserve battery power, but the meter is monitoring the batteries.   When you want to see the display, connect the terminal marked "C" to a positive volt source (+ and - terminals should still be connected).   "C" can be hard wired to have the display showing all of the time or can be used through a momentary contact switch to see the battery status by depressing the momentary contact switch. Another method for installation would be to connect "C" to a terminal coming from a switch key that goes hot when the key is turned on. Remember that + and - must always be connected.    NOTE: For the meter to be reset to full, it is necessary that the meter sees the charging voltage for as little as 1/2 second. If you have your meter hooked up only from a switched source for both the + and "C" terminal, you must switch this on during the recharge cycle for less than 1 second to reset the meter. We will send it within 2 business days after recieving your payment, we will send by Flat Air Mail. Please allow 5--12 business days for delivery to USA (delivery time is upon your location,),it may take 7 to 25 business days for other countries except for USA. All the goods will be ship to the address which display in the payal.If your need ship to the other address,please inform, If need to send quicker using express like Fedex, DHL, UPS,or USPC, or you'd like regist air mail, please contact, we will alter the shipping fees for you. Thanks